Search for: All records

Abstract Poisson's ratio for earth materials is usually assumed to be positive (V_p/V_s > 1.4). However, this assumption may not be valid in the critical zone because near Earth's surface effective pressures are low (<1 MPa), porosity has a wide range (0%–60%), there are significant texture changes (e.g., unconsolidated vs. fractured media), and saturation ranges from 0% to 100%. We present P‐wave (V_p) and S‐wave (V_s) velocities from seismic refraction profiles collected in weathered crystalline environments in South Carolina and Wyoming. Our data show that ∼20% of the subsurface has negative Poisson's ratios (V_p/V_svalues < 1.4), a conclusion supported by borehole sonic logs. The low V_p/V_svalues are confined to the fractured bedrock and saprolite. Our data support the hypothesis that weathering‐generated microcracks can produce a negative Poisson's ratio and that V_p/V_svalues can thus provide insight into important critical zone weathering processes. 

Abstract For decades, seismic imaging methods have been used to study the critical zone, Earth's thin, life‐supporting skin. The vast majority of critical zone seismic studies use traveltime tomography, which poorly resolves heterogeneity at many scales relevant to near‐surface processes, therefore limiting progress in critical zone science. Full‐waveform tomography can overcome this limitation by leveraging more seismic data and enhancing the resolution of geophysical imaging. In this study, we apply 2D full‐waveform tomography to match the phases of observed seismograms and elucidate previously undetected heterogeneity in the critical zone at a well‐studied catchment in the Laramie Range, Wyoming. In contrast to traveltime tomograms from the same data set, our results show variations in depth to bedrock ranging from 5 to 60 m over lateral scales of just tens of meters and image steep low‐velocity anomalies suggesting hydrologic pathways into the deep critical zone. Our results also show that areas with thick fractured bedrock layers correspond to zones of slightly lower velocities in the deep bedrock, while zones of high bedrock velocity correspond to sharp vertical transitions from bedrock to saprolite. By corroborating these findings with borehole imagery, we hypothesize that lateral changes in bedrock fracture density majorly impact critical zone architecture. Borehole data also show that our full‐waveform tomography results agree significantly better with velocity logs than previously published traveltime tomography models. Full‐waveform tomography thus appears unprecedentedly capable of imaging the spatially complex porosity structure crucial to critical zone hydrology and processes. 

Abstract Weathering processes weaken and break apart rock, freeing nutrients and enhancing permeability through the subsurface. To better understand these processes, it is useful to constrain physical properties of materials derived from weathering within the critical zone. Foliated rocks exhibit permeability, strength and seismic anisotropy–the former two bear hydrological and geomorphological consequences while the latter is geophysically quantifiable. Each of these types of anisotropy are related to rock fabric (fractures and foliation); thus, characterizing weathering‐dependent changes in rock fabric with depth may have a range of implications (e.g., landslide susceptibility, groundwater modeling, and landscape evolution). To better understand how weathering effects rock fabric, we quantify seismic anisotropy in saprolite and weathered bedrock within two catchments underlain by the Precambrian Loch Raven schist, located in Oregon Ridge Park, MD. Using circular geophone arrays and perpendicular seismic refraction profiles, anisotropy versus depth functions are created for material 0–25 m below ground surface (bgs). We find that anisotropy is relatively low (0%–15%) in the deepest material sampled (12–25 m bgs) but becomes more pronounced (29%–33%) at depths corresponding with saprolite and highly weathered bedrock (5–12 m bgs). At shallow soil depths (0–5 m bgs), material is seismically isotropic, indicating that mixing processes have destroyed parent fabric. Therefore, in situ weathering and anisotropy appear to be correlated, suggesting that in‐place weathering amplifies the intrinsic anisotropy of bedrock.